Restoration

If anyone as information on any of these pics please forward them to me. These are located on the western slopes of the Cascades about 30miles east of Eugene, OR. The fellow who owns them plans on making a museum, and restoring them to working condition. Funds are a big problem I suspect. However I also suspect some of these may be past working condition. Experts may comment here please.

Cylinder of large a hit and miss. Nuts are about 2"	Block assembly for hit and miss.

Piston for hit and miss, cylinder is just above it.	Boiler, not sure for what. About 8 ft high at highest.

Twin cylander setup. Flywheel in background.	This is about 7ft or better across.

Small Donkey engine.	A small cylinder, about 8-9inch bore.

Close view of Cylinder if above right picture.	Heres a HP/LP horizontal. This has possiblities.

Close view of the HP/LP horizontal.	Close up of fly wheel of HP\LP horizontal.

Belt powered water pump.	Hit and miss (I think.) Saw power?????

Close up of above right engine.

Cylinder of large a hit and miss. Nuts are about 2"

Block assembly for hit and miss.

Piston for hit and miss, cylinder is just above it.

Boiler, not sure for what. About 8 ft high at highest.

Twin cylander setup. Flywheel in background.

This is about 7ft or better across.

Small Donkey engine.

A small cylinder, about 8-9inch bore.

Close view of Cylinder if above right picture.

Heres a HP/LP horizontal. This has possiblities.

Close view of the HP/LP horizontal.

Close up of fly wheel of HP\LP horizontal.

Belt powered water pump.

Hit and miss (I think.) Saw power?????

Close up of above right engine.

www.horizonps.com

hosted by Horizon Professional Services
Copyright © 2002 [HPS]. All rights reserved.
Revised: January 29, 2003